In Deco Router mode, wired satellites belong downstream of the main Deco LAN or a downstream switch; AP mode has different wiring flexibility.
Before you change anything
This is a diagnostic entry point. The source supports the general check, not a confirmed root cause for your device.
What to check first
Was a second or upstream path added?
Record the exact model, hardware revision, firmware and recent change before adjusting settings. If you cannot answer the question, keep the cause open.
Narrow the likely path
| Observation | Next check |
|---|---|
| Light or app says offline | Use the correct model and role chart; color alone is inconclusive. |
| Node will not join | Check the specific mesh family and parent/child setup sequence. |
| Feature menu differs | Compare the current firmware and hardware revision with the vendor guide. |
Decision after the first test
Confirm the mode in the Deco app, add units to one network first, then connect one cable path and verify Ethernet backhaul in the network map.
Use a documented next step
Verify before escalating
After each change, repeat the exact failed task. If the result is unchanged, restore the previous setting and use the official support link for your exact hardware revision. Don’t assume a menu or capability from a related model.
Official sources
- Deco Ethernet backhaul wiring and checks (full_text; checked 2026-11-01)
Check your exact US model, hardware revision, and firmware on the linked support page before changing settings.