Starlink bypass steps and recovery differ by hardware generation; some routers require a factory reset to exit bypass.
Before you change anything
This is a diagnostic entry point. The source supports the general check, not a confirmed root cause for your device.
What to check first
Is the hardware-specific reset/recovery procedure available?
Record the exact model, hardware revision, firmware and recent change before adjusting settings. If you cannot answer the question, keep the cause open.
Narrow the likely path
| Observation | Next check |
|---|---|
| Adding a second router | Check for double NAT and whether AP mode or a documented gateway mode fits. |
| Service changed after bridge/passthrough | Restore saved cabling and verify TV/voice as well as internet. |
| Menu is absent | Check provider policy; some gateways cannot expose that mode. |
Decision after the first test
Identify Router 3, Router Mini, Gen 2 or another kit before changing mode. Confirm the return path and required Ethernet adapter first.
Use a documented next step
Verify before escalating
After each change, repeat the exact failed task. If the result is unchanged, restore the previous setting and use the official support link for your exact hardware revision. Don’t assume a menu or capability from a related model.
Official sources
- Starlink bypass mode and generation-specific recovery (search_excerpt; checked 2026-11-01)
Check your exact US model, hardware revision, and firmware on the linked support page before changing settings.