ASUS Ethernet Backhaul Mode is a system-level choice that may leave an unwired node offline. Per-node priority can be safer in mixed wiring.
Before you change anything
This is a diagnostic entry point. The source supports the general check, not a confirmed root cause for your device.
What to check first
Was global Ethernet-only mode enabled before every node was wired?
Record the exact model, hardware revision, firmware and recent change before adjusting settings. If you cannot answer the question, keep the cause open.
Narrow the likely path
| Observation | Next check |
|---|---|
| Light or app says offline | Use the correct model and role chart; color alone is inconclusive. |
| Node will not join | Check the specific mesh family and parent/child setup sequence. |
| Feature menu differs | Compare the current firmware and hardware revision with the vendor guide. |
Decision after the first test
Check every node's current uplink in the AiMesh map before switching modes, then verify each node after the change.
Use a documented next step
Verify before escalating
After each change, repeat the exact failed task. If the result is unchanged, restore the previous setting and use the official support link for your exact hardware revision. Don’t assume a menu or capability from a related model.
Official sources
- ASUS Ethernet Backhaul Mode and per-node priority (full_text; checked 2026-11-01)
Check your exact US model, hardware revision, and firmware on the linked support page before changing settings.